Best 5 Ricardos Triple Liquor Baby Back Ribs Recipes

RICARDO'S TRIPLE LIQUOR BABY BACK RIBS

Steps:

• Cut each pork rack into 3 to 4 pieces.
• In a large pot, boil enough water to fully submerse ribs.
• Add the onion, garlic, ribs, and beer to the boiling water.
• Bring to a slow boil, cover and cook for 30-45 minutes.
• While the meat is cooking, combine BBQ sauce and whiskey in a bowl(mix to taste).
• Remove boiled ribs from pot and liberally coat with BBQ sauce and wrap tightly with aluminum foil.
• Put ribs in a roasting pan in a 200°F oven for 2 hours.
• While ribs are roasting, combine remaining ingredients to make the glaze.
• When the ribs are done roasting, remove from foil and grill over a low heat for about 15-20 minutes, turning 4-6 times and brushing with glaze after each turn.

BAKED BABY BACK RIBS

Steps:

• In a small bowl, combine the brown sugar, chipotle chile powder, salt, onion powder, garlic powder, seafood seasoning and black pepper.
• Place each slab of ribs on a piece of aluminum foil large enough to fold over and seal, then place on a baking sheet. Do not seal the ribs in the foil yet (see Cook's Note). Generously sprinkle the dry rub on both sides of the ribs. Place in the refrigerator, meat-side down and uncovered, for at least 1 hour. Preheat the oven to 300 degrees F.
• In a small bowl, combine the apple cider, apple cider vinegar, maple syrup, Worcestershire and minced garlic. Pour half the liquid over each slab and tightly seal each in the aluminum foil, crimping the edges to make a packet.
• Transfer the foil packets and baking sheet to the oven and bake until the meat is tender and starts to pull away from the bones, about 2 hours.
• Remove the sheet pan from the oven. Carefully open the aluminum packets and pour the braising liquid into a small saucepan. Bring the liquid to a simmer over medium heat until it becomes a thick and syrupy glaze, about 4 minutes.
• While the braising liquid reduces, line a baking sheet with foil and gently transfer the ribs to it. Position a rack on the top level of the oven and preheat the broiler.
• Using a pastry brush, generously brush the ribs with about half the glaze. Place the ribs under the broiler for about 1 minute. Brush with the remaining glaze and return to the broiled until charred in spots, about 1 minute more. Slice each rack between the bones into 2-rib portions and serve.

BABY BACK RIBS

Steps:

• For the rub: The day before cooking, mix the turbinado sugar, salt, paprika, chili powder, granulated garlic, onion powder, ground cumin, ground mustard, cayenne pepper and black pepper together.
• For the ribs: Take a slab of ribs and turn over so the curved side is up. Using your fingernail or a knife, pry under the membrane until you can put your finger under it and then pull it off.
• Sprinkle this side of the ribs with about 1 tablespoon rub, and then about 1 tablespoon yellow mustard. Use the mustard to help evenly distribute the seasoning. Turn the ribs over and repeat the process. Cover and store in the refrigerator overnight.
• To cook, start a smoker and bring the temp to 200 degrees F. Use apple or cherry wood chunks to provide smoke and flavor. Place the ribs in the smoker, curved side down. Smoke for 2 hours at 200 degrees F, and then raise the temperature to 250 degrees F for about 2 1/2 hours. Check for tenderness by testing if the bones will pull apart with a slight bit of pressure. If they are still tough, allow to cook for another 30 minutes.
• Remove from the smoker. For dry-style ribs, sprinkle with about 1 tablespoon rub. For wet-style ribs, glaze with the BBQ sauce.

NO FAIL BBQ BABY BACK RIBS (GRILL)

Steps:

• Remove silver skin from bone side of ribs. Never used to do this, but now understand why the pros do. Using the tine of a dinner fork helps get things started, then it just peels off.
• Put a large sheet of foil on the counter and place the ribs meat side down. You want enough foil to VERY lightly wrap (or tent) the ribs for grilling.
• All the spice measurements above are estimates. We like things a bit on the zippy side, but not burning hot -- just a little bite. With that said, we season the bone side of the ribs heavy with garlic powder, medium heavy with cayenne, medium heavy with pepper, and light with salt. Really hard to over do it, as after 4+ hours on the grill, the spices seem to mellow.
• Flip the ribs and repeat the seasoning. Again, may look heavy, but the flavors kinda vanish during cooking. Why you need to try it once and adjust to taste the 2nd time. I never taste the garlic no matter how much I put on, but the cayenne does adjust the spiciness. Even when we go pretty heavy with the cayenne, it is not over-powering.
• Lightly wrap the ribs. You want to create a tent on top so the foil does not touch the meat. Pull up the ends lightly and seal. You do want to seal things so moisture does not escape. You can put these in the fridge all day, or put on the grill immediately.
• I have a Weber Genesis gas grill that has a front, center and rear burner. Don't have to pre-heat, but I only turn on the front burner to low-medium -- grill will heat to about 250 degrees. Place the ribs towards the rear of the grill (away from the burner). Leave them there for 2 hours. Nothing you need to do except make sure the temp stays around 250. 200 is fine, 300 is fine -- but lower seems to produce better results.
• After 2 hours, open the foil and coat with BBQ sauce. Should be a lot of juice in the foil at this point. If not, add some water, beer, or something. Re-seal the foil and let them go another 2 hours.
• Now the tricky part. Pull the ribs towards the front the grill. Get a couple wide spatulas, open the foil, and carefully lift the rack of ribs from the foil and place directly on the center of the grill. At this point, the ribs will be pretty much done. Remove the foil from the grill. Turn on all the burners and coat the ribs with sauce. Close the lid. Things should start smoking from the sauce dripping and burning. If things are not smoking, turn up the heat. Keep an eye on things at this point. You do want a nice char, but you don't want to overdo it. Maybe 10-20 minutes for this step.
• Get the 2 spatulas and remove to a cookie sheet or platter. Enjoy.
• If you like Sweet Baby Ray's Original, you will like these. Fall off the bone every single time, and they require very little effort or attention. You can adjust the base seasoning to your liking. I have made these with the same general recipe and process from anywhere between 3 hours and 6 hours with very little loss in outcome. Hence the reason I call it "no fail".

OVEN-BAKED BABY BACK RIBS

Steps:

• Preheat the oven to 250 degrees F (120 degrees C).
• Mix ancho chile powder, white and brown sugars, salt, black pepper, cumin, dry mustard, cayenne, and chipotle pepper in a small bowl until combined.
• Place rib rack, meat-side down, on heavy-duty aluminum foil. Prick back of the rack several times with a knife.
• Generously apply a coating of dry rub to all sides of the rack. Store any remaining dry rub in an airtight container for future use.
• With the meat facing down, fold foil around the rack to create a tight seal. Transfer to a sheet pan.
• Bake in the preheated oven until tender and cooked through, about 2 hours. Remove and cool 15 minutes.
• Increase oven temperature to 350 degrees F (175 degrees C).
• Open foil, drain and discard any accumulated juices and fat. Brush barbeque sauce on all sides of the rack.
• Turn the rack on the foil so the meat is facing up. Return to the oven, leaving the foil open and bake for 10 minutes. Remove from the oven and brush another layer of barbeque sauce on the meat side only. Repeat baking and brushing with sauce 4 more times, for a total of 50 minutes baking time.
• Cut rack into individual rib segments and serve with more barbeque sauce.