Best 2 Steamed Corn Custards With Crab Recipes

STEAMED CORN CUSTARDS WITH CRAB

Steps:

• Make custard:
• Cook corn in a 1-quart saucepan of boiling salted water until very tender, 3 to 5 minutes, and drain in a sieve.
• Purée milk and hot corn in a blender until almost smooth, then force through a very fine sieve into a bowl, discarding solids. Whisk in egg and salt and divide custard among ramekins.
• Steam custards in a steamer set 1 inch above simmering water, covered with lid, until centers are set and a thin knife inserted into center of 1 custard comes out clean, 6 to 8 minutes. Remove ramekins from steamer with tongs and cool custards slightly.
• Make crab topping while custards cool:
• Coarsely chop 1/4 cup crabmeat and reserve remainder for another use. Heat butter in a small heavy skillet over moderate heat until foam subsides, then cook crab, stirring constantly, until heated through, about 2 minutes. Stir in chives.
• Serve custards topped with crab.

CHEF JOHN'S CREAMY CORN CUSTARD

Steps:

• Preheat oven to 325 degrees F (165 degrees C). Butter six 6-ounce glass or ceramic ramekins. Set ramekins into a 2-inch deep baking dish.
• Place corn into a large saucepan and stir in cream, salt, and cayenne pepper. Bring to a simmer and remove from heat; stir in milk.
• Transfer corn mixture to a blender and pulse several times to get the mixture moving. Blend on high speed until smooth and creamy.
• Whisk egg yolks with eggs until smooth in a mixing bowl. Slowly whisk about 1/4 cup hot corn mixture into eggs until the corn mixture is incorporated. Repeat several times more until all the corn mixture is combined with eggs.
• Divide corn mixture equally into the 6 ramekins. Pour hot tap water into the baking dish to come about halfway up the sides of the ramekins.
• Bake in the preheated oven until custards are just set, 30 to 35 minutes. Let custards cool for about 10 minutes before serving in ramekins or unmolding onto serving plates. To unmold, insert a knife between the custard and the ramekin, go around the edge with knife to loosen, and turn over onto a plate to unmold.