Best 5 Old Fashioned Sponge Candy Seafoam Recipes

SPONGE CANDY

Steps:

• Line a 9×9 baking dish with parchment paper and set aside.
• In a medium heavy-bottomed, tall sided saucepan over medium heat, stir together the corn syrup, brown sugar, and vinegar. Stir frequently, bringing mixture to a boil.
• Once the mixture is boiling, attach a candy thermometer to the side of the saucepan, making sure the tip of the thermometer is in the boiling liquid, but not touching the bottom of the pan.
• Continue to cook on medium without stirring the candy until it reaches 300°F on your candy thermometer.
• Remove the pan from the heat and stir in the baking soda. Mixture will bubble up creating the bubbles and texture in the candy. Mix only until the baking soda is evenly combined, careful not to over-stir as this will deflate the bubbles.
• Pour the mixture into the prepared pan as evenly as you can. Tilt the pan around to help the candy spread, but don't hit the pan or use a spatula to spread, as this will deflate the bubbles. It's ok if it's not perfectly even.
• Sprinkle with flaked sea salt if desired, and allow the candy to cool in the pan for at least an hour.
• Remove candy from the pan using the parchment paper to lift it out and break the candy into pieces using a mallet or a knife. I don't worry too much about the pieces being perfectly shaped.

OLD FASHIONED SPONGE CANDY

Steps:

• line the bottom and sides of a 9x9" square pan -- with aluminum foil -- butter foil and set aside.
• combine sugar, vinegar and corn syrup in a heavy pan --
• stir once over medium heat till sugar dissolves --
• heat until mixture reaches the hard crack stage or 290*-310* on candy thermometer.
• remove from heat, carefully stir in baking soda.mixture will foam quite high --
• pour mixture into prepared pans, set aside at room temperature until firm --
• invert pan to remove candy.
• peel foil off and break candy into small pieces --
• store in an airtight container at room temperature -- .

OLD FASHIONED SPONGE CANDY (SEAFOAM)

Steps:

• Combine sugar,syrup and vinegar in a large deep saucepan over medium heat, stirring until sugar dissolves. Then continue cooking WITHOUT stirring until 300^ on candy thermometer. Remove quickly and stir in soda(it will foam up high), mix well and pour right away into a buttered 9x13-inch baking pan. DO NOT SPREAD OUT, AIR WILL BE DEFLATED and candy will stick to teeth...When cool; break into pieces. --- Note: If you desire you can spread 1 cup of chocolate chips, white chips, butterscotch chips or mint chips on the hot candy in the pan and spread to coat the top and sprinkle with nuts before it cools.

SEA FOAM CANDY

Steps:

• Combine light brown and white sugars, water, corn syrup, and salt in a heavy 2 quart saucepan. Cook covered until mixture boils rapidly. Remove lid, place candy thermometer in pan, and cook without stirring to 260 degrees F (127 degrees C). Remove from heat.
• Beat egg whites until stiff. Pour hot syrup in thin stream over egg whites, beating constantly with electric mixer on high speed. Add vanilla and pecan flavoring.
• Continue beating until soft peaks form and candy starts to lose its gloss. Stir in pecans and drop by spoonfuls onto waxed paper. When candy has set, store in airtight container.

SPONGE CANDY

Steps:

• Line 9-inch square cake pan with 2-inch-high sides with foil, extending foil over sides. Generously butter foil. Combine sugar, corn syrup and vinegar in heavy large deep saucepan. Stir over medium heat until sugar dissolves. Continue cooking without stirring until clip-on candy thermometer registers 300°F, swirling pan occasionally, about 18 minutes. Remove from heat. Immediately add baking soda and stir until well combined (mixture will foam vigorously). Immediately pour mixture into prepared pan. Cool completely.
• Using foil as aid, lift, candy from pan; fold down foil sides. Cut or break candy into large pieces (save any small pieces or shreds to use as a topping for ice cream). (Can be made 1 week ahead. Store airtight at room temperature.)